Specifications:
Manufacturer: SmartLabs Design
Manufacturer Product No.: 2476D, INSTEON SwitchLinc Dimmer, White
UPC: 891114000082
Patent No.: U.S. Patent No. 7,345,998, International patents pending
Warranty: 2 years, limited (Upgradeable to 7 years)
Operation
On-Levels: 32 locally, increments of 1% with software
Ramp Rates (full-ON to full-OFF): 0.125 to 9 seconds if programmed locally, 0.125 seconds to 9 minutes if programmed remotely
LED Indicator: 9 White LEDs, Optional Green, Blue, Amber, or Red with #2400L kit
Operation Modes: INSTEON only, X10 only, INSTEON and X10 Combo Mode
Combo Mode Message Order: INSTEON, X10, INSTEON cleanup
Multi-Way Circuit Support: One SwitchLinc Dimmer controls load, Cross-Link any number of SwitchLinc Dimmers or other INSTEON Controllers
Setup Memory: Non-volatile EEPROM
INSTEON Features
INSTEON Addresses: 1 hard-coded out of 16,777,216 possible
INSTEON Links: 417 out of 16,777,216 possible
INSTEON Powerline Frequency: 131.65 KHz
INSTEON Minimum Transmit Level: 3.2 Vpp into 5 Ohms
INSTEON Minimum Receive Level: 10 mV
INSTEON Messages Repeated: Yes
Mechanical
Paddle Type: True rocker action
Color: White installed
Wire Nuts: 5 included
Mounting: Mounts in single or multiple-ganged junction box. Control 200 W less load for each immediately adjacent SwitchLinc Dimmer installed. For example, 600 W load control becomes 400 W with another dimmer to the immediate right or left. Use a triple-gang box with a mechanical switch in the center to avoid de-rating.
Operating Conditions: Indoors, 40 to 104°F, up to 85% relative humidity
Dimensions: 4.1" H x 1.8" W x 1.2" D
Weight: 3.6 oz
Electrical
Supply Voltage: 120 Volts AC +/- 10%, 60 Hertz, single phase
Surge Protection: MOV rated for 150 Volts
Neutral Wire: Required
Power Wire Leads: 6", 16 AWG, stranded,600V, 105°C insulation, ends stripped and tinned, LINE (black), LOAD (red), NEUTRAL (white)
Maximum Amps: 5 amps
Ground Lead: 6", 18 AWG, stranded, bare copper
Load Types: Wired-in incandescent lighting devices
Maximum Load: 600 Watts (uses 12-Amp triac dimmer)
Minimum Load: No minimum load required
Certification: Safety tested for use in USA and Canada (ETL #3017581)
X10 Features
X10 Primary Address: 1 optional (comes unassigned)
X10 Scene Addresses: 255 possible
X10 Status Response: Supported
X10 Resume Dim: Supported (by setting Local On-Level to zero)
X10 Powerline Frequency: 120 KHz
X10 Minimum Transmit Level: 3.2 Vpp into 5 Ohms
X10 Minimum Receive Level: 20mV into 5 Ohms
X10 Messages Repeated: No