Specifications
Manufacturer: SecureLinc
Manufacturer Product No.: Plus #7
Dimensions: 10 13/16" x 8" x 2 1/8" (275mm x 203mm x 55mm)
Weight: 990g (2.2 pounds) without batteries
Zones: 28 wireless, 2 hardwired
Hardwired Zone Requirements: 2.2 k. E.O.L. resistance (max. resistance of wires 220)
Zone Types: Interior follower, perimeter, perimeter follower, delay 1, delay 2, 24h silent, 24h audible, fire, non-alarm, emergency, gas and flood
User Codes: 8 codes, 4 digits each
Control Facilities: Integral keypad, PowerCode hand-held transmitters, wireless commander, MCM-140+, remote telephone, local or remote computer
Display: Single line, back lighted 16-character LCD and 4 LED indicators
Arming Modes: AWAY, HOME, AWAY-INSTANT, HOMEINSTANT, LATCHKEY, FORCED, BYPASS
Alarm Types: Silent alarm, siren alarm or sounder (internal) alarm, in accordance with zone attributes
Siren Signals: Continuous (intrusion / 24 hours / panic); triple pulse - pause - triple pulse (fire)
Siren Timeout: Programmable (4 min. by default)
Internal Sounder Output: At least 85 dBA at 10 ft. (3m)
Supervision: Programmable time frame for inactivity alert
Data Retrieval: Status, alarm memory, trouble, event log
Operating Frequencies: 315 MHz (in USA & Canada) or other UHF channels per local requirement in the country of use
Receiver Type: Super-heterodyne, fixed frequency
Receiver Range: 600 ft. (180m) in open space
Antenna Type: Spatial diversity
Coding: PowerCode and/or CodeSecure™
Power Supply: Plug-in transformer 120 VAC, 60 Hz / 9 VAC, 1A (in the U.S.A.); 230 VAC, 50 Hz / 9 VAC, 1A
Current Drain: Approx. 65 mA standby, 800 mA at full load and in alarm
Site External Siren Current (EXT): 450 mA max @ 10.5 VDC when powered by AC & DC (battery)
Site Internal Siren Current (INT): 450 mA max. @ 10.5 VDC when powered by AC & DC (battery)
PGM Output Current: 100 mA max.
Detector 1 & 2 Total (Sum) Current: 100 mA max.
High Current / Short Circuit Protection: All outputs are protected (current limited)
Battery Test: Once every 10 seconds
Built-in Modem: 300 baud, Bell 103 protocol
Data Transfer to Local Computer: Via RS232 serial port
Report Destinations: 2 central stations, 4 private telephones, 1 pager
Reporting Format Options: SIA, Pulse 4/2 1900/1400 Hz, Pulse 4/2 1800/2300 Hz, Contact ID, Scancom
Pulse Rate: 10, 20, 33 and 40 pps - programmable
Message to Private Phones: Tone or voice
Message to Pager: PIN No. Alarm Type, Zone No.
Operating Temperature Range: 32°F to 120°F (0°C to 49°C)
Storage Temperature Range: -4°F to 140°F (-20°C to 60°C)
Humidity: 85% relative humidity, @ 30°C (86°F)
Approvals: FCC compliant, UL listed
Warranty: 1 year, limited

Magnetic Contact Transmitters

Dimensions: 3 3/16" x 7/8" x 15/16" (81mm x 22mm x 23.5mm)
Weight: 1.2 oz. (34g), excluding battery
Battery Weight: 0.45 oz. (13g)
Frequency: 315, 433.92, 868.95
Transmitter's ID Code: 24-bit digital word, over 16 million combinations, pulse width modulation Overall Message Length: 36 bits Alarm Inputs: 2: one internal, one external, each with a separate 24-bit transmitter
Auxiliary Input Circuit Type: N.C. / E.O.L., selected with DIP switch
E.O.L. Resister Required: 47 kilo ohms
Message Repetition: Once every 3 minutes or one-shot, selectable via on-board DIP switch
Supervision: Signaling at 60-minute intervals via reed switch or aux. input, including battery supervision
Tamper Reporting: Every 3 minutes until restored
Power Source: 3V Lithium CR-2-type battery, Panasonic or Sanyo only
Battery Life Expectancy: 3 years (typical use)
Operating Temperature: 32° F to 120° F (0° C to 49° C)
Standards: FCC compliant, UL listed

Wireless PIR Detectors

Dimensions: 4.1" x 2.4" x 1.3" (104mm x 60mm x 32mm)
Weight: 2.5 oz. (71g)
Maximum Coverage Range: 30' x 30' (9m x 9m), 90°
Pet Immunity: Up to 85 lbs. (18kg)
Vertical Adjustment: 3-position adjustment scale: 6 ft., 7 ft., and 8 ft. (1.8m, 2.1m, and 2.4m)
Battery Type: 3.6 Volt lithium thionyl chloride (LiSOCl2) battery, size 1/2AA, Tadiran TL-2150
Nominal Battery Capacity: 1 Ah
Standby Current: 0.015mA
Transmit Current: 12 mA (including LED)
Battery Life Expectancy: 3 years (typical use)
Detector: Dual-element low-noise pyroelectric sensor
Pulse Counter: Programmable to 1,3 or 5 pulses
Rearm Timer: 2 minutes after last alarm
Frequencies: 315, 433.92, 868.95, 869.2625 MHz
Transmission Sequence: 3 data bursts at variable intervals within 3 seconds
ID: 24-bit factory-selected code, >16 million possible combinations
Total Message Length: 36 bits
Operating Temperature: 14° F to 120° F (-10° C to 49° C)
Storage Temperature: -4° F to 140° F (-20° C to 60° C)
FRI Protection: >20 V/m up to 1000 MHz
Standards: FCC and Directive 1999/5/EC compliant, UL listed

Miniature Keyfob Transmitters

Dimensions: 2 1/8" x 1 1/4" x 1/2" (53.5mm x 31.5mm x 12.5mm)
Weight: 3/4 oz./21g (including battery)
Frequency: 315, 433.92, 868.95 MHz
Modulation: ASK (ON-OFF keying)
Coding: 28-bit ID, 4-bit function code and 32-bit rolling code
Transmission Duration: Up to 2 seconds
Power Supply: 12V alkaline battery, type GP 23A or equivalent
Current Consumption: 11 mA (during transmission)
Battery Life Expectancy: 1 year (typical use)
Operating Temperature: 32° F to 120° F (0° C to 49° C)
Standards: FCC compliant, UL listed