Specifications
Manufacturer: SmartLabs Design
Manufacturer Product No.: 2450, I/O Linc
UPC: 689076403542
Patent No.: U.S. Patent No. 7,345,998, International patents pending
Color: White
Warranty: 2 years, limited (Upgradeable to 7 years)

Operation
Status LED: White (Bright when relay closed, dim when relay open)
Sensor Status LED: Green (On when sensor closed, Off when sensor open)
Set Button: Toggles output relay On/Off. Also used for setup.
Momentary Duration: Adjustable, 2 – 25 seconds
Operation Modes: INSTEON only, X10 only, INSTEON and X10 Combo Mode
Combo Mode Message Order: INSTEON, INSTEON confirmation, X10
Multi-Way Circuit Support: Yes
Setup Memory: Non-volatile EEPROM

INSTEON Features
INSTEON Addresses: 1 hard-coded out of 16,777,216 possible
INSTEON Links: 417
INSTEON Powerline Frequency: 131.65 KHz
INSTEON Minimum Transmit Level: 3.2 Vpp into 5 Ohms
INSTEON Minimum Receive Level: 10 mV
INSTEON Messages Repeated: Yes

Mechanical
I/O Terminals: 5V (10mA), GND, Sense, N/C, N/O, Common (28-16 gauge wire)
Input jack: 1/8” mini jack input (GND, Sense)
Input Type: Contact closure only
Output Relay Capacity: 5A @ 30 Volts (AC or DC)
Operating Conditions: Indoors, 40 to 132°F, up to 85% relative humidity
Dimensions: 4.5" H x 2.5" W x 1.5" D
Weight: 4.6 oz

Electrical
Supply Voltage: 120 Volts AC +/- 10%, 60 Hertz, single phase
Surge Protection: 1/8” mini jack input (GND, Sense) Power Plug : 3-pin grounded
Pass-through Outlet: Uncontrolled 3-prong (with ground), 120V, 15A
Certification: Safety tested for use in USA and Canada (ETL #3017581)

X10 Features
X10 Primary Address: Two optional (comes unassigned). One for input, one for output
X10 Scene Addresses: Not supported
X10 Status Request: Supported
X10 Powerline Frequency: 120 KHz
X10 Minimum Transmit Level: 3.2 Vpp into 5 Ohms
X10 Minimum Receive Level: 3.2 Vpp into 5 Ohms
X10 Messages Repeated: No

Miniature Magnetic Contact Switch Specifications
Manufacturer: SECO-LARM
Manufacturer Product No.: SEC-SM204WH
Compatibility: Works with nearly all standard, hardwired alarm systems
Dimensions: 1 1/4" long and 1/4" thick, with 1-inch operational gap
Case Construction: Weatherproof. high-impact ASS plastic with self-adhesive backing
Magnet: Alnico 5
Rating: 0.1 Amp / 100VDC (max.); 1 Amp / 10VDC (max.)
Temperature: -15° F to 160° F (-25° C to 70° C)
Leads: 15", 22-guage
Approval: UL listed

20 Foot 2 Conductor, 22-Gauge/AWG Interconnect Wire Specifications
Manufacturer: West Penn Wire
Wire Type: 2-Conductor, 22-Gauge/AWG
Length: 20'
Pairs: 1
AWG Size: 22
Stranding: 7 x 30
Nominal Insulation Thickness: 0.01" (.25mm)
Jacket Type: PVC
Nominal Jacket Thickness: 0.015 (.38mm)
Nominal Outside Diameter: .127 (3.23mm)
Nominal D.C.R Resistance @ 20°: 17 ohms per 1000 feet
Color Code: Conductors: black, red; jacket: gray, white, brown
Materials: ATSM bare copper conductor with PVC insulation and an overall PVC jacket
Approvals: UL listed NEC type CMR, constructed in accordance with UL standard 444; complies with UL 1666 vertical shaft flame test; meets 300 volt requirements as specified in section 800-51 of the NEC